Club Car Precedent 2014, Руководство по техническому обслуживанию и ремонту

Страница: 399 / 548

TORQUE CONVERTER (GASOLINE VEHICLE) Drive Clutch
25
767
Figure 25-5 Shock Absorbers
2700
Figure 25-6 Rear Shackle
5. Raise the rear of the vehicle enough to allow the centerline of the drive clutch to drop below the frame rails
for access to the bolt securing the drive clutch. Place jack stands beneath the frame rails just forward of the
spring mounts.
See following WARNING.
WARNING
• Lift only one end of the vehicle at a time. Use a suitable lifting device (chain hoist or hydraulic floor
jack) with 1000 lb. (454 kg) minimum lifting capacity. Do not use lifting device to hold vehicle in raised
position. Use approved jack stands of proper weight capacity to support the vehicle and chock
the wheels that remain on the floor. When not performing a test or service procedure that requires
movement of the wheels, lock the brakes.
6. Remove the drive clutch retaining bolt (17) and mounting washer (19) (Figure 25-7, Page 25-7) . See also Figure
25-3, Page 25-4. See following NOTE.
NOTE: The drive clutch mounting bolt has left-hand threads.
The crankshaft has left-hand threads at the clutch mounting hole.
6.1. Use the drive clutch holder tool (1) while tightening or loosening the drive clutch retaining bolt (2) (Figure
25-3, Page 25-4) .
6.2. Hook clutch holder on boss (3) of pulley located behind drive clutch and push against the adjacent boss
with holder.
7. Lubricate the threaded portion of the clutch puller tool (1) with a light oil and thread the clutch puller tool into the
clutch retaining bolt hole
(Figure 25-4, Page 25-4) .
8. Use a 1/2-inch drive air wrench to tighten the clutch puller tool. The drive clutch (2) will pull free of the crankshaft.
9. Support the drive clutch assembly in your hand and back the clutch puller tool out of the crankshaft.
2014 Precedent ® Golf Car Maintenance and Service Manual Page 25-5