Club Car Precedent 2014, Руководство по техническому обслуживанию и ремонту

Страница: 391 / 548

UNITIZED TRANSAXLE (GASOLINE VEHICLE) Forward/Reverse Shifter Cable
24
DANGER
• Repair all fuel leaks before operating the vehicle.
34. Start the engine and check for fuel leaks. If the fuel pump leaks, a rebuild kit must be installed to replace all
gaskets and diaphragms.
35. Place the neutral lockout cam in the OPERATE position.
36. Adjust the engine RPM setting. See Engine RPM Adjustment on page 22-9.
FORWARD/REVERSE SHIFTER CABLE
See General Warnings on page 1-2.
If the Forward/Reverse shifter cable is damaged in any way, it must be replaced.
FORWARD/REVERSE SHIFTER CABLE REMOVAL
NOTE: Before removing cable, note cable routing and positions of wire ties or other devices securing the cable to the
vehicle. When installed, cable must be routed and secured as it was originally.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-3.
2. Loosen lock nut (26) where the cable attaches to the shifter (Figure 24-58, Page 24-24) . Push in the end of the
ball joint socket (27) to release the cable from the ball stud (17).
3. Loosen retaining nuts (28) to release cable from bracket (10).
4. Release the wire tie (25) that is clipped to the bucket and secure the cable.
5. Use a screwdriver or flat blade to pry cable end off the stud on the lever arm.
6. Compress clips on boot enough to push boot through the cable bracket (24). Remove cable from vehicle.
FORWARD/REVERSE SHIFTER CABLE INSTALLATION
1. From the Forward/Reverse shifter, route the cable toward the passenger side of the vehicle so it lies against the
side of the front body, turns 90° and passes over the battery, through the opening to the engine, and through the
cable bracket to the shifter arm
(Figure 24-58, Page 24-24) . Make sure cable does not touch muffler.
2. Place cable in bracket (10) and secure in position with two retaining nuts (28). Tighten retaining nuts to 43
in·lb (4.9 N·m).
3. Attach ball joint socket (27) to stud (17) on shifter. Tighten lock nut (26) to 43 in·lb (4.9 N·m).
4. Position cable near the clip and secure it with wire tie (25).
5. Push cable boot through cable bracket (24). Clips on boot should snap in place to secure the cable in position.
6. Place end of cable over stud on lever arm. Push down on cable end to snap the cable onto the stud.
2014 Precedent ® Golf Car Maintenance and Service Manual Page 24-23