Club Car Precedent 2014, Руководство по техническому обслуживанию и ремонту

Страница: 378 / 548

24
Unitized Transaxle Removal UNITIZED TRANSAXLE (GASOLINE VEHICLE)
1.2. Place a new seal (15) in the adapter ring with the seal lip facing toward the adapter ring lip (Figure 24-13,
Page 24-9) . Use an axle seal tool (P/N 1014162) and mallet to tap it in until it seats firmly in position. A
hydraulic press may also be used with the axle seal tool.
1.3. Clean adapter ring seat(s) in the axle tube.
1.4. Apply Loctite ® 603 to the outer diameter of the adapter ring.
1.5. Place the oil seal and adapter ring assembly into the axle tube with the seal lip facing away from the bearing
(Figure 24-14, Page 24-9) . Use an axle seal tool (P/N 1014162) and mallet to tap it in until it seats firmly
in position. See following CAUTION.
CAUTION
• Clean any residual oil from the exposed end of the axle shaft and from the oil seal area prior to
installing the axle shaft to prevent oil from coming in contact with brakes.
2. Install the rear axle into the transaxle. See following NOTE.
2.1. Insert the shaft, splined end first, through the seal and into the axle tube. Be careful not to damage the seal
on the inside of the axle tube hub. Advance the shaft through to the bearing on the shaft, then rotate it to
align the shaft splines with the splined bore of the differential side gear. Continue advancing the shaft until
the bearing on the axle is firmly seated within the axle tube hub seat.
2.2. Use a pair of snap ring pliers to install the retaining ring (1) inside axle tube hub so that it seats against
the axle bearing assembly and into the machined slot in the inside wall of the axle tube hub (Figure
24-11, Page 24-9) .
NOTE: If the retaining ring, axle bearing, or sleeve must be replaced, the entire axle shaft assembly must be replaced.
2.3. Place a 1/4 to 3/8-inch (6 to 10 mm) diameter rod against the retaining ring and tap lightly at four to five
locations around the retaining ring to ensure it is properly seated. See following WARNING.
WARNING
• Be sure the retaining ring is properly seated in its groove. If the ring is not properly installed, the axle
assembly will separate from the transaxle and damage the axle assembly and other components. Loss
of vehicle control could result, causing severe personal injury or death.
3. If a new oil seal was installed, allow 24 hours before operating the vehicle to allow the Loctite ® 603 to fully cure.
UNITIZED TRANSAXLE REMOVAL
See General Warnings on page 1-2.
1. Turn the key switch to the OFF position and remove the key, and place the Forward/Reverse handle in the
NEUTRAL position.
2. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-3.
3. Close the fuel shut-off valve on fuel tank (Figure 22-13, Page 22-21) .
4. Detach all wires, hoses, etc. connecting the powertrain to the vehicle.
4.1. Disconnect the carburetor vent tube from the carburetor (Figure 24-15, Page 24-11) .
4.2. Disconnect the air intake hose from the carburetor (Figure 24-16, Page 24-11) .
Page 24-10 2014 Precedent ® Golf Car Maintenance and Service Manual