Club Car Precedent 2014, Руководство по техническому обслуживанию и ремонту

Страница: 50 / 548

4
Rear Body – Two-Passenger Vehicles BODY AND TRIM
REAR BODY – TWO-PASSENGER VEHICLES
See General Warnings on page 1-2.
UNIVERSAL ACCESSORY MOUNTING
NOTE: The Structural Accessory Module (SAM) uses clearance holes for accessories to attach to the canopy support
located inside the SAM.
The Structural Accessory Module (SAM) includes two mounting locations on both the driver side and the passenger
side
(Figure 4-9, Page 4-12) . These serve as common attachment points (1) for various accessories. Accessories that
can be mounted on the SAM include single or dual sand bottles, sand bucket, and the club cleaner.
1
621
Figure 4-9 Universal Accessory Mounting
SEAT BACK AND STRUCTURAL ACCESSORY MODULE (SAM)
SAM Removal
1. If the vehicle has a canopy, the rear upright supports must be removed from the SAM.
2. Remove four bolts (4) to release the SAM (3) from the vehicle (Figure 4-10, Page 4-13) .
SAM Installation
Position the SAM (3) over its mounting holes and secure with four screws (4). Tighten screws to 71 in·lb (8 N·m).
Seat Back
The seat back (1) is secured to the SAM (3) with two screws (2) (Figure 4-10, Page 4-13) . When replacing the
backrest, tighten screws (2) to 51 in·lb (5.8 N·m).
Bag Rack Removal
1. Remove two screws (10) to release the bag hoop (6) and related components from the SAM (3) (Figure 4-10,
Page 4-13) .
2. Bag strap (8) may be released by removing two plastic barrel connectors (9) and one screw (12).
3. Bag strap buckles (7) may be snapped out of bag hoop (6).
Bag Rack Installation
Installation is the reverse of removal. Tighten screw (12) to 31 in·lb (3.5 N·m) and screws (10) to 53 in·lb (6 N·m).
Page 4-12 2014 Precedent ® Golf Car Maintenance and Service Manual