Cleco 17BP B, Инструкция по эксплуатации

Страница: 46 / 62

46 P1890E/EN 2010-08
91e_Trouble shooting en bedingt.fm, 10.09.2010
Troubleshooting
9
Problem Possible cause Action
RF15.4 data communication between controller and tool
No serial communication
is possible between the
controller and the base
station. (Error displayed
after
Accept <F1> is
pressed in Communica-
tion/Tool .)
Wrong serial cable is
used.
➔
Use a null modem cable (crossed).
Wrong port is selected
for connection with the
controller.
➔
In the Communication/Tool screen of the con-
troller, check the port settings for RF Serial .
Note: If the settings are changed, it is necessary to
press Accept <F1> in order to apply the settings.
➔
Check that the serial cable is connected to the
selected port.
Selected port is used for
serial data transmission.
➔
In the Communication/Data Transmission
screen of the controller, check whether serial
data transmission is enabled (the protocol is set
to anything except NONE), and whether the
same port is being used.
➔
If so, select a different port or disable serial data
transmission.
➔
Check all available tools as necessary. The
same port cannot be used for serial data trans-
mission and data communication with base sta-
tion tool.
Power outlet not active.
➔
Check the voltage at the outlet socket where the
base station is plugged in for power supply.
No RF15.4 data commu-
nication is possible
between controller and
tool. Settings are not config-
ured correctly.
➔
In the Communication/Tool screen of the con-
troller, check that RF settings of the base station
correspond to the settings of the tool, which are
displayed in the
868MHz RF settings submenu
of the tool. The settings for Channel, Network ID
and Tool ID must match.
Distance between base
station and tool is too
great. If channel 1 is selected, the distance can be up to
98.4 ft (30 m). If channel 2 or 3 is selected, the dis-
tance can be up to 32.8 ft (10 m).
➔
Increase output power on base station and on
the tool, or move the base station closer to the
tool.