Cleco 17BP B, Инструкция по эксплуатации

Страница: 8 / 62

8 P1890E/EN 2010-08
91b_1_5 en bedingt.fm, 10.09.2010
Safety
1
1.2 Basic requirements for safe working practices
You should read all instructions. Nonobservance of the instructions below may result in electrical shock,
burns and serious injuries.
1.3 Operator training
All operators must be trained and experienced before operating the 17BP.
The 17BP may be repaired by authorized technicians only.
1.4 Personal protective equipment
When working
•
Wear the protective goggles to protect against spurting metal splinters.
Danger of injury by being wrapped up in and caught by machinery
•
Wear a hairnet.
• Wear close-fitting clothing.
• Do not wear jewelry.
CAUTION! Work area
➔
Ensure there is enough space in the work area.
➔
Keep the work area clean.
➔
Electrical safety
➔
Protect the 17BP from rain and moisture. Use only in the inner zone (IP40).
➔
Follow the safety instructions printed on the battery and charger.
➔
Use 17BP only with power supply (PS) by Cleco.
Safety of persons
➔
The head can close when pushing the start button inadvertently (eg when putting down the tool). Fin-
gers can be bruised or severed. Do not reach into the open head.
➔
Ensure a secure standing position. Maintain balance.
➔
Make sure that the PS is securely installed before operating the 17BP.
➔
Hold the 17BP tightly in the hand – be prepared for high short-term reaction torques.
➔
Do not carry the 17BP with the finger on the start button –
prevent accidental operation.
➔
Do not open the battery. Acid will cause injury.
➔
Do not look into the laser beam of tools with built-in barcode scanners.
➔
Follow generally valid and local safety and accident prevention rules.
Safe working with and around fastening tools
➔
Inspect bits for visible damage and cracks. Replace damaged bits immediately.
➔
Disconnect the 17BP from the PS before replacing the bits.
➔
Only use bits for machine-controlled fastening tools.
➔
Only use bits from Cleco, see 10.9 Socket for C1, C3, optional, page 66.
➔
Do not attach sockets on the head aslant.
➔
Make sure that the bits are securely inserted.