Cleco 17BP B, Инструкция по эксплуатации

Страница: 16 / 62

16 P1890E/EN 2010-08
91b_1_5 en bedingt.fm, 10.09.2010
Product description
3
3.2.11 Barcode scanner
For tools of the 17BP series, the built-in barcode scanner is a class 2 laser scanner with a wavelength of
650 nm.
The barcode scanner reads one-dimensional linear barcodes:
Depending on how the controller is programmed, there are two different operating modes:
Barcode as release for further rundowns
➔
Press the start button on the tool; this activates the barcode scanner.
The successful scan is acknowledged by an acoustic signal.
➔
Press the start button on the tool again; this starts the rundown.
If is necessary to read another barcode, proceed as follows.
Barcode not necessary as release for further rundowns
➔
From the Scanner tool menu, select Read barcode .
➔
Press the start button on the tool; this activates the barcode scanner.
The successful scan is acknowledged by an acoustic signal.
➔
Press the start button on the tool again; this starts the rundown.
Alternative: Assign the Read barcode function to the left function key <F1> on the tool.
➔
Press the left function key <F1> on the tool once.
➔
Press the start button on the tool again; this activates the barcode scanner.
Programming the barcode scanner is described in the programming manual of the controller.
CAUTION!
Eye injury from class 2 laser beam
➔
Do not look into the laser beam window when the laser is on.
➔
Repair any damage immediately.
Damage of the optical components can cause laser radiation.
➔
Modifications to the barcode scanner and procedures not outlined in these operating instructions
are strictly prohibited.
➔
Take defective devices out of operation immediately.
Scanning operation Acoustic signal
• Successful 50 ms long
• Faulty
• Not within 3 seconds
• Canceled by pressing the start button
3 times in rapid succession
LASER RADIATION
DO NOT LOOK INTO THE BEAM
CLASS 2 LASER
IN ACCORDANCE WITH
EN 60825-1:1994
P < 1mW;
λ
= 630 nm