Cleco 17BP B, Инструкция по эксплуатации

Страница: 21 / 62

91c_LCD en bedingt.fm, 10.09.2010
P1890E/EN 2010-08 21
LCD display
7
7 LCD display
The LCD display on the tool is divided into the result display, status display, operating menu and system
error messages.
7.1 Result display
First line – result:
The status is displayed in alternation with the Application being used.
The LCD display consists of a three lines, each with 6 characters,
to display the status, torque and angle. The result display is updated after the rundown
ends.
OK Result is OK
NOK Result is not OK
OFF Torque encoder offset error
CAL Torque encoder calibration error
ENC Angle encoder error
IP Current overload in output section
IIT Requested motor output is too high
TMAX Maximum fastening time exceeded
RC Rundown terminated by disabled start signal
TS Depth sensor signal was enabled at start or
was subsequently disabled during the rundown (only for 17BP series)
Tq< Torque too low
Tq> Torque too high
A< Angle Low
A> Angle High
Error Error occurred
Second line – Shut-off torque in Nm:
T
Torque Target
Third line – Shut-off angle in degrees:
A
Shut-off angle
The symbol at the top right shows an interrupted data connection to the control.
OK
T12.00
A100
OK
T12.00
A100