Administration: File Management
File Operations
81
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
6
-
If the server is selected by name in the Server Definition, there is no need to select
the IP Version related options.
-
IPv6 Address Type
—Select the IPv6 address type (if used). The options are:
Link Local
—The IPv6 address uniquely identifies hosts on a single network link. A
link local address has a prefix of
FE80
, is not routable, and can be used for
communication only on the local network. Only one link local address is supported.
If a link local address exists on the interface, this entry replaces the address in the
configuration.
Global
—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
-
Link Local Interface
—Select the link local interface from the list.
•
Server IP Address/Name
—Enter the IP address or name of the TFTP server.
•
Source
—Enter the update file name.
STEP 3
Click
Apply
to begin the operation.
To update a system configuration file using SCP:
STEP 1
Click
Administration
>
File Management
>
File Operations
.
STEP 2
Enter the following fields:
•
Operation Type
—Select
Update File
.
•
Destination File Type
—Select one of the configuration file types to update.
•
Copy Method
—Select
SCP
.
STEP 3
To enable SSH server authentication (which is disabled by default), click
Edit
by
Remote
SSH Server Authentication
. This takes you to the
page to
configure the SSH server
STEP 4
Return to this page.
STEP 5
Select one of the following methods to perform
SSH Client Authentication
:
•
Use SSH Client System Credentials—
Sets permanent SSH user credentials. Click
System Credentials
to go to the SSH User Authentication page where the user/
password can be set once for all future use.
•
Use SSH Client One-Time Credentials—
Enter the following:
