Cisco SF500-24, Руководство администратора

Страница: 416 / 477

Configuring SNMP
SNMP Versions and Workflow
Cisco 500 Series Stackable Managed Switch Administration Guide 407
22
If you decide to use SNMPv1 or v2:
STEP 1
Navigate to the
SNMP -> Communities
page and click Add. The community can be
associated with access rights and a view in Basic mode or with a group in
Advanced mode. There are two ways to define access rights of a community:
• Basic mode—The access rights of a community can configure with Read
Only, Read Write, or SNMP Admin. In addition, you can restrict the access to
the community to only certain MIB objects by selecting a view (defined in the
Views page).
• Advanced Mode—The access rights of a community are defined by a group
(defined in the
Groups
page). You can configure the group with a specific
security model. The access rights of a group are Read, Write, and Notify.
STEP 2
Choose whether to restrict the SNMP management station to one address or allow
SNMP management from all addresses. If you choose to restrict SNMP
management to one address, then input the address of your SNMP Management
PC in the IP Address field.
STEP 3
Input the unique community string in the Community String field.
STEP 4
Optionally, enable traps by using the Trap Settings page.
STEP 5
Optionally, define a notification filter(s) by using the Notification Filter page.
STEP 6
Configure the notification recipients on the Notification Recipients SNMPv1,2
page.
If you decide to use SNMPv3:
STEP 1
Define the SNMP engine by using the
Engine ID
page
.
Either create a unique
Engine ID or use the default Engine ID. Applying an Engine ID configuration will
clear the SNMP database.
STEP 2
Optionally, define SNMP view(s) by using the Views page. This will limit the range
of OIDs available to a community or group.
STEP 3
Define groups by using the
Groups
page
.
STEP 4
Define users by using the SNMP Users page , where they can be associated with
a group. If the SNMP Engine ID is not set, then users may not be created.
STEP 5
Optionally, enable or disable traps by using the
Trap Settings
page
.
STEP 6
Optionally, define a notification filter(s) by using the Notification Filter page .