obeying predefined rules for management of incoming and outgoing data
packets.
IMPORTANT
For detailed information on the predefined rules for smart
VLAN packet management, refer to the
table at the bottom of this section.
To connect the unit to a VLAN that is part of the local wireless network, do
the following steps:
1.
Click the
-vlan settings
link under
ADVANCED SETTINGS
in the
left-hand settings menu.
• The
VLAN SETTINGS
).
Figure 40. Configurator GUI (VLAN SETTINGS dialog)
2.
Connect the unit to a VLAN that is part of the local wireless
network by checking the
Enable VLANs
check-box.
3.
Check the
Enable VLANs
check-box.
4.
Enter the management identification number of the VLAN (used
to communicate with the device's operating system) in the
Management VLAN ID:
field.
NOTE
The same Management VLAN ID must be used on all
Fluidmesh devices that are part of the same mesh
network.
5.
Enter the native identification number (the VLAN ID implicitly
assigned to untagged packets received on trunk ports) in the
Native VLAN ID:
field.
6.
Save the VLAN settings by clicking the
Save
button. Alternatively,
clear the settings by clicking the
Reset
button.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 86 of 138
