• The
Static Routes
dialog will be shown (
Figure 28. Configurator GUI (Static Routes window)
To enter a new static route, do the following steps:
1.
Enter the
Subnet
,
Netmask
and
Gateway
designators in the
correct fields of the
Add new static route
section.
2.
Click the
add
button.
• If the new static route is valid, it will be added to the
Active
static routes
list.
6.7.3. Pass lists and Block lists
The Pass list or Block list function is a security feature that prevents fake
IP addresses from intercepting or intruding on the network.
A Pass list is a group of Fluidmesh transceivers, described as a list of
linked pairs. Within the list, each transceiver unit is considered a valid hop
in the routing table. If a Pass list is created, all transceiver units that are
not on the Pass list are excluded from packet routing.
Conversely, a Block list is a group of Fluidmesh transceivers that are
excluded by the routing table computation, and to which data packets
must not be routed. If a Block list is created, all transceiver units that are
on the Block list are excluded from packet routing.
IMPORTANT
The same Pass list or Block list must be applied to all
transceiver units that are part of a defined network.
Failure to use the same Pass list or Block list may cause units
to incorrectly receive, or be incorrectly excluded from, network
traffic.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 71 of 138
