• When inserting each connector into a shielded Ethernet port, the
connector's inner jacket must form a positive contact with the
Ethernet port.
• When each RJ45 connector is plugged into the correct Ethernet
port of the Cisco FM1000 Gateway, lock the bottom of the RJ45
connector using the side retaining screws.
• When all RJ45 connectors are connected to the unit, make sure
that the bottom cover of the unit is correctly secured to the unit
enclosure.
4.1.4. Supplying power to the Cisco FM1000 Gateway
CAUTION
When connecting the Cisco FM1000 Gateway to a power
supply, be sure to follow the instructions in this section at all
times.
Failure to follow these instructions may result in irreparable
damage to the unit and/or other connected hardware, and will
also invalidate the product warranty.
IMPORTANT
For technical data on which power sources are compatible with
the Cisco FM1000 Gateway, refer to
.
The Cisco FM1000 Gateway can be provided with power using the
following methods:
• A 12 Vdc/5A 60W power source.
When providing the power source for the Cisco FM1000 Gateway,
remember the following important points:
• Install the power source as close to the unit as possible to minimize
voltage drop. The maximum suggested distance is 50ft (15m).
Connecting power to the Cisco FM1000 Gateway
NOTE
For detailed comparative information on which Fluidmesh
hardware devices are capable of accepting power
through IEEE 802.3at or IEEE 802.3af power sources, or
through a DC IN power source, refer to
.
Hardware installation
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 28 of 138
