Cisco D9854, Руководство по установке и настройке, Страница: 365 / 440

341
Alarm Message
Type Message Cause/Remedy Description Severity ID
FPGA status Set FPGA ID does not
match HW FPGA
ID
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major 39000
FPGA status Clear FPGA loaded
successfully and
reset
– – Major 39000
MIP Output
Spacing (D9854
with Single
Frequency
Network only)
Set MIP Output
Spacing Erratic -
Data lost
Cause: Current
transport rate
exceeds the
configured rate for
ASI output.
Remedy: Increase
output rate.
Contact the uplink
to verify the
expected bit rate
settings.
Severe
differences in
the MIP
packets
detected on the
input versus
the MIP
packets
transmitted to
the ASI output.
Minor 40500
MIP Output
Spacing (D9854
with Single
Frequency
Network only)
Clear MIP Output
Spacing Stable – – Minor 40500
FEC USB Flash
(D9854-I only)
Set FEC USB Option
not installed Cause: FEC USB
connector not
installed.
Remedy: Ensure
that the FEC USB
connector and
FLASH module
are installed.
FEC USB
option not
detected.
Major 92300