Cisco D9854, Руководство по установке и настройке, Страница: 220 / 440

Chapter 5 Web GUI Setup and Monitoring
196
5 Choose Enable from the TS/ONID Check drop-down list if you want to restrict
the incoming transport stream to the transport ID and transport original network
ID listed below. If the incoming stream does not match the specified transport
stream, the CAM will not decrypt. The default is Disable.
6 If you set the TS/ONID Check to Enable, you must define the Transport ID and
Original Network ID . If the incoming stream does not match the specified IDs
here, the CAM will not decrypt. You can enter a value in a range from 0 to 65535.
7 From the CAM TS Handling drop-down list, choose EntireTS to use the CAM to
decrypt the entire transport stream, or choose ServicesOnly to use the CAM to
decrypt only the PIDs being used by the active services.
8 Click Apply .
Setting up the Common Interface Program Description
1 From the CI Slot drop-down list, choose the CAM slot to use for decryption. If
you choose AUTO for PE 1, the software automatically assigns the slot capable
of decrypting the stream.
Note: If CI Slot is set to AUTO , the Decryption Mode must be set to ON .
Choose TOP to use the top CAM slot for decryption or choose BOTTOM to use
the bottom CAM slot for decryption.
2 The Decryption Mode determines whether to decrypt the channel or to specify
the specific components to decrypt (ON, OFF, Comp). Choose ON (default) to
decrypt the entire program entry. Choose Comp to decrypt specific components,
as specified in the CI Component Setup list below.
Note: If the CI Slot is set to Auto for PE1, then Decryption Mode can only be set
to ON .
3 Click Apply .
Setting up the CI Component
If Comp is selected as the Decryption Mode , you must configure the parameters in
the CI Components Setup area. The CI Component Setup area allows you to insert
and maintain customized records.