Cisco D9854, Руководство по установке и настройке, Страница: 364 / 440

Chapter 6 Service and Maintenance
340
Alarm Message
Type Message Cause/Remedy Description Severity ID
FPGA status Set FPGA Init failed to
go high Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major 39000
FPGA status Set FPGA Init and
Done failed to go
low
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major 39000
FPGA status Set FPGA Init went
LOW (CRC error) Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major 39000
FPGA status Set FPGA Done failed
to go high Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major 39000
FPGA status Set SW ver outside
upper or lower
limit
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major 39000
FPGA status Set FPGA ID does not
match FPGA
DESIGNATION
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the
unit, notify Cisco
Services if the
problem persists.
FPGA setup
failure or the
FPGA binary
identity does
not match the
FPGA registers.
Major 39000