Cisco Catalyst 4500 Series, Руководство по настройке программного обеспечения, Страница: 450 / 2086

9
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS
Chapter 9 Configuring Interfaces
Defining and Using Interface-Range Macros
•
TFTP
• Secure Shell (SSH)
•
DHCP-based autoconfiguration
• SNMP (only the ENTITY-MIB and the IF-MIB)
•
IP ping
• Interface features
–
Speed—10 Mb/s, 100 Mb/s, 1000Mb/s, and autonegotiation
– Duplex mode—Full, half, and autonegotiation
–
Loopback detection
• Cisco Discovery Protocol (CDP) (only on WS-C4900M and WS-C4948)
•
IPv4 access control lists (ACLs)
• Routing protocols (only on WS-C4900M and WS-C4948)
•
AAA
Caution Before enabling a feature on the Ethernet management port, ensure that the feature is supported. If you
try to configure an unsupported feature on an Ethernet management port, the feature might not work
properly, and the switch might fail.
Configuring the Ethernet Management Port
To specify the Ethernet management port, enter fastethernet1 .
To disable the port, use the shutdown interface configuration command. To enable the port, use the
no shutdown interface configuration command.
To determine the link status to the PC, you can monitor the LED for the Ethernet management port:
• The LED is green (on) when the link is active.
•
The LED is off when the link is down.
• The LED is amber when there is a POST failure.
To display the link status, use the show interfaces fastethernet 1 privileged EXEC command.
Defining and Using Interface-Range Macros
You can define an interface-range macro to automatically select a range of interfaces for configuration. Before using the macro
keyword in the interface-range macro command string, you must define the macro.