Cisco Catalyst 4500 Series, Руководство по настройке программного обеспечения, Страница: 1319 / 2086

49-39
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 49 Configuring 802.1X Port-Based Authentication
Configuring 802.1X Port-Based Authentication
Switch(config)# ip device tracking
Step 2
Configure RADIUS VSA to forward authentication.
Switch(config)# radius-server vsa send authentication
Step 3 Configure static ACL for the interface.
Switch(config)# int g2/9
Switch(config-if)# ip access-group pacl-4 in
Interface Configuration Example
Switch# show running-configuration interface g2/9
Building configuration...
Current configuration : 617 bytes
!
interface GigabitEthernet2/9
switchport
switchport access vlan 29
switchport mode access
switchport voice vlan 1234
access-group mode prefer port
ip access-group pacl-4 in
speed 100
duplex full
authentication event fail action authorize vlan 111
authentication event server dead action authorize vlan 333
authentication event server alive action reinitialize
authentication host-mode multi-auth
authentication order dot1x
authentication port-control auto
authentication timer restart 100
authentication timer reauthenticate 20
authentication timer inactivity 200
mab eap
dot1x pae authenticator
end
Switch#
Switch# show ip access-list pacl-4
10 permit ip host 1.1.1.1 host 2.2.2.2
20 permit icmp host 1.1.1.1 host 2.2.2.2
Switch#
Debug Commands for DACL
The IP device tracking table contains the host IP address learned through ARP or DHCP.
The following command displays the constraints on the IP device tracking table:
Switch# show ip device tracking all
IP Device Tracking = Enabled
IP Device Tracking Probe Count = 3
IP Device Tracking Probe Interval = 30
--------------------------------------------------------------
IP Address MAC Address Interface STATE
--------------------------------------------------------------
50.0.0.12 0015.60a4.5e84 GigabitEthernet2/9 ACTIVE