Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 908 / 1538

1-40
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring Network Security with ACLs
Using VLAN Maps with Router ACLs
Use the no vlan access-map command with a sequence number to delete a map sequence. Use the no
version of the command without a sequence number to delete the map.
This example shows how to configure a VLAN access map to drop and log IP packets. Here IP traffic
matching the permit entries in net_10 is dropped and logged.
DomainMember(config)# vlan access-map ganymede 10
DomainMember(config-access-map)# match ip address net_10
DomainMember(config-access-map)# action drop log
DomainMember(config-access-map)# exit
This example shows how to configure global VACL logging parameters:
DomainMember(config)# vlan access-log maxflow 800
DomainMember(config)#
vlan access-log threshold 4000
Note
For complete syntax and usage information of the commands used in this section, see the Cisco IOS LAN
Switching Command Reference :
http://www.cisco.com/en/US/docs/ios/lanswitch/command/reference/lsw_book.html
Using VLAN Maps with Router ACLs
Note
Router ACLs and VLAN maps are not supported on switches running the LAN base feature set.
To access control both bridged and routed traffic, you can use VLAN maps only or a combination of
router ACLs and VLAN maps. You can define router ACLs on both input and output routed VLAN
interfaces, and you can define a VLAN map to access control the bridged traffic.
If a packet flow matches a VLAN-map deny clause in the ACL, regardless of the router ACL
configuration, the packet flow is denied.
Note
When you use router ACLs with VLAN maps, packets that require logging on the router ACLs are not
logged if they are denied by a VLAN map.
If the VLAN map has a match clause for the type of packet (IP or MAC) and the packet does not match
the type, the default is to drop the packet. If there is no match clause in the VLAN map, and no action
specified, the packet is forwarded if it does not match any VLAN map entry.
•
VLAN Maps and Router ACL Configuration Guidelines, page 1-40
•
Examples of Router ACLs and VLAN Maps Applied to VLANs, page 1-41
VLAN Maps and Router ACL Configuration Guidelines
These guidelines are for configurations where you need to have an router ACL and a VLAN map on the
same VLAN. These guidelines do not apply to configurations where you are mapping router ACLs and
VLAN maps on different VLANs.
The switch hardware provides one lookup for security ACLs for each direction (input and output);
therefore, you must merge a router ACL and a VLAN map when they are configured on the same VLAN.
Merging the router ACL with the VLAN map might significantly increase the number of ACEs.