Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 428 / 1538

1-26
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring Interface Characteristics
Using the Ethernet Management Port
This example shows how to create a multiple-interface macro named macro1 :
Switch# configure terminal
Switch(config)#
define interface-range macro1 gigabitethernet1/0/1 - 2,
gigabitethernet1/0/5 - 7, tengigabitethernet1/0/1 -2
Switch(config)# end
This example shows how to enter interface-range configuration mode for the interface-range
macro
enet_list :
Switch# configure terminal
Switch(config)# interface range macro enet_list
Switch(config-if-range)#
This example shows how to delete the interface-range macro enet_list and to verify that it was deleted.
Switch#
configure terminal
Switch(config)# no define interface-range enet_list
Switch(config)# end
Switch#
show run | include define
Switch#
Using the Ethernet Management Port
This section has this information:
•
Understanding the Ethernet Management Port, page 1-26
• Supported Features on the Ethernet Management Port, page 1-28
•
Configuring the Ethernet Management Port, page 1-29
• TFTP and the Ethernet Management Port, page 1-29
Understanding the Ethernet Management Port
The Ethernet management port, also referred to as the Fa0 or fastethernet0 port , is a Layer 3 host port
to which you can connect a PC. You can use the Ethernet management port instead of the switch console
port for network management. When managing a switch stack, connect the PC to the Ethernet
management port on a Catalyst 3750-X or Catalyst 3750-E stack member.
When connecting a PC to the Ethernet management port, you must assign an IP address.