Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 546 / 1538

1-16
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling
Configuring Layer 2 Protocol Tunneling
Use the no l2protocol-tunnel [ point-to-point [ pagp | lacp | udld ]] interface configuration command to
disable point-to-point protocol tunneling for one of the Layer 2 protocols or for all three. Use the no
l2protocol-tunnel shutdown-threshold [ point-to-point [ pagp | lacp | udld ]] and the no
l2protocol-tunnel drop-threshold [[ point-to-point [ pagp | lacp | udld ]] commands to return the
shutdown and drop thresholds to the default settings.
Step 5
l2protocol-tunnel
shutdown-threshold
[ point-to-point
[ pagp | lacp | udld ]] value
(Optional) Configure the threshold for packets-per-second accepted for
encapsulation. The interface is disabled if the configured threshold is
exceeded. If no protocol option is specified, the threshold applies to each of
the tunneled Layer 2 protocol types. The range is 1 to 4096. The default is
to have no threshold configured.
Note
If you also set a drop threshold on this interface, the
shutdown-threshold value must be greater than or equal to the
drop-threshold value.
Step 6 l2protocol-tunnel drop-threshold
[ point-to-point [ pagp | lacp | udld ]]
value
(Optional) Configure the threshold for packets-per-second accepted for
encapsulation. The interface drops packets if the configured threshold is
exceeded. If no protocol option is specified, the threshold applies to each of
the tunneled Layer 2 protocol types. The range is 1 to 4096. The default is
to have no threshold configured.
Note If you also set a shutdown threshold on this interface, the
drop-threshold value must be less than or equal to the
shutdown-threshold value.
Step 7 no cdp enable Disable CDP on the interface.
Step 8 spanning-tree bpdufilter enable Enable BPDU filtering on the interface.
Step 9
exit Return to global configuration mode.
Step 10
errdisable recovery cause l2ptguard (Optional) Configure the recovery mechanism from a Layer 2
maximum-rate error so that the interface is re-enabled and can try again.
Errdisable recovery is disabled by default; when enabled, the default time
interval is 300 seconds.
Step 11 l2protocol-tunnel cos value (Optional) Configure the CoS value for all tunneled Layer 2 PDUs. The
range is 0 to 7; the default is the default CoS value for the interface. If none
is configured, the default is 5.
Step 12 end Return to privileged EXEC mode.
Step 13
show l2protocol Display the Layer 2 tunnel ports on the switch, including the protocols
configured, the thresholds, and the counters.
Step 14
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose