Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 143 / 1538

1-11
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Managing Switch Stacks
Understanding Switch Stacks
For configuration information, see the “Provisioning a New Member for a Switch Stack” section on
page 1-27 .
Effects of Replacing a Provisioned Switch in a Switch Stack
When a provisioned switch in a switch stack fails, is removed from the stack, and is replaced with
another switch, the stack applies either the provisioned configuration or the default configuration to it.
The events that occur when the switch stack compares the provisioned configuration with the
provisioned switch are the same as those described in the
“Effects of Adding a Provisioned Switch to a
Switch Stack” section on page 1-9 .
Effects of Removing a Provisioned Switch from a Switch Stack
If you remove a provisioned switch from the switch stack, the configuration associated with the removed
stack member remains in the running configuration as provisioned information. To completely remove
the configuration, use the
no switch stack-member-number provision global configuration command.
Hardware Compatibility and SDM Mismatch Mode in Switch Stacks
The Catalyst 3750-X switch supports only the desktop Switch Database Management (SDM) templates.
All stack members use the SDM template configured on the stack master.
Version-mismatch (VM) mode has priority over SDM-mismatch mode. If a VM-mode condition and an
SDM-mismatch mode exist, the switch stack first attempts to resolve the VM-mode condition.
You can use the show switch privileged EXEC command to see if any stack members are in
SDM-mismatch mode.
For more information about SDM templates and SDM-mismatch mode, see Chapter 1, “Configuring
SDM Templates.”
For information about mixed hardware stacks, see the Cisco Software Activation and Compatibility
Document on Cisco.com.
Switch Stack Software Compatibility Recommendations
To ensure complete compatibility between stack members, use the information in this section and also
in the
“Hardware Compatibility and SDM Mismatch Mode in Switch Stacks” section on page 1-11 .
All stack members must run the same Cisco IOS software image and feature set to ensure compatibility
between stack members. For example, all stack members should run the universal software image and
have the IP services feature set enabled for the Cisco IOS Release 12.2(53)SE2 or later.
For more information, see the “Stack Protocol Version Compatibility” section on page 1-12 and the
Cisco Software Activation and Compatibility Document on Cisco.com.
For information about mixed hardware and software stacks, see the Cisco Software Activation and
Compatibility Document on Cisco.com.