Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 221 / 1538

1-7
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring SDM Templates
Displaying the SDM Templates
number of directly connected hosts: 3K
number of indirect routes: 8K
number of qos aces: 0.5K
number of security aces: 1K
On next reload, template will be “desktop vlan” template.
To return to the default template, use the no sdm prefer global configuration command.
This example shows how to configure a switch running the IP Base or IP Services feature set with the
routing template:
Switch(config)# sdm prefer routing
Switch(config)# end
Switch# reload
Proceed with reload? [confirm]
This example shows how to configure the IPv4-and-IPv6 default template:
Switch(config)#
sdm prefer dual-ipv4-and-ipv6 default
Switch(config)# exit
Switch# reload
Proceed with reload? [confirm]
Displaying the SDM Templates
Use the show sdm prefer privileged EXEC command with no parameters to display the active template.
To display the resource numbers supported by the specified template, use the show sdm prefer [ access
| default | dual-ipv4-and-ipv6 { default | vlan } | indirect-ipv4-and-ipv6-routing | routing | vlan ]
privileged EXEC command.
Note
On switches running the LAN Base feature set, routing values shown in all templates are not valid.
This is an example of output from the show sdm prefer command that displays the template in use:
Switch# show sdm prefer
The current template is "desktop default" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses: 6K
number of igmp multicast routes: 1K
number of unicast routes: 8K
number of directly connected hosts: 6K
number of indirect routes: 2K
number of policy based routing aces: 0
number of qos aces: 0.5K
number of security aces: 1K
Although the outputs are the same on all switches, the outputs for the routing templates are valid only
on switches running the IP Base or IP Services feature set. This is an example of output from the
show
sdm prefer routing command:
Switch# show sdm prefer routing
"desktop routing" template:
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.