Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 331 / 1538

1-43
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring IEEE 802.1x Port-Based Authentication
Configuring 802.1x Authentication
•
If you use the errdisable recovery cause security-violation global configuration command to
configure error-disabled recovery, the port is automatically re-enabled. If error-disabled recovery is
not configured for the port, you re-enable it by using the
shutdown and no-shutdown interface
configuration commands.
• You can re-enable individual VLANs by using the clear errdisable interface interface-id
vlan
[ vlan-list ] privileged EXEC command. If you do not specify a range, all VLANs on the port are
enabled.
Beginning in privileged EXEC mode, follow these steps to enable voice aware 802.1x security:
This example shows how to configure the switch to shut down any VLAN on which a security violation
error occurs:
Switch(config)# errdisable detect cause security-violation shutdown vlan
This example shows how to re-enable all VLANs that were error disabled on port Gi4/0/2.
Switch# clear errdisable interface GigabitEthernet4/0/2 vlan
You can verify your settings by entering the show errdisable detect privileged EXEC command.
Configuring 802.1x Violation Modes
You can configure an 802.1x port so that it shuts down, generates a syslog error, or discards packets from
a new device when:
•
a device connects to an 802.1x-enabled port
• the maximum number of allowed about devices have been authenticated on the port
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 errdisable detect cause
security-violation shutdown vlan Shut down any VLAN on which a security violation error occurs.
Note If the shutdown vlan keywords are not included, the entire port
enters the error-disabled state and shuts down.
Step 3 errdisable recovery cause
security-violation (Optional) Enable automatic per-VLAN error recovery.
Step 4 clear errdisable interface interface-id
vlan
[ vlan-list ]
(Optional) Reenable individual VLANs that have been error disabled.
• For interface-id specify the port on which to reenable individual
VLANs.
•
(Optional) For vlan-list specify a list of VLANs to be re-enabled. If
vlan-list is not specified, all VLANs are re-enabled.
Step 5 shutdown
no-shutdown
(Optional) Re-enable an error-disabled VLAN, and clear all error-disable
indications.
Step 6 end Return to privileged EXEC mode.
Step 7 show errdisable detect Verify your entries.
Step 8
copy running-config startup-config (Optional) Save your entries in the configuration file.