Circutor AFQm Series, Инструкция по эксплуатации

Страница: 8 / 108

8
AFQm
Instruction Manual
The centre of gravity of some devices may be found at a considerable height.
Therefore, when handling with a forklift, it is recommended that the device be
securely fastened and that no abrupt manoeuvres made. The device should
not be lifted more than 20 cm off the ground
When unloading and moving the device, use a forklift with forks long enough to support the en-
tire length of the base. Otherwise, the forks should be long enough to support at least ¾ of said
depth. The forks must be flat and supported firmly by the base. Raise the device by placing the
forks underneath the profile that supports the device. (
Figure 2
).
There might be an offset in the centre of gravity from the centre of the cabinet,
as a result of the uneven distribution of loads inside the device. The neces-
sary precautions must be taken to prevent the device from tipping over during
abrupt operations.
Figure 2: Unloading with a forklift�
When unpacking the device, pay attention to prevent damaging the device if you are using cut-
ting tools, such as cutters, scissors or knives.
The AFQm devices cabinet type, there are also 4 rings (diameter : 28 mm) in the top panel so
that they can be transported by a crane. The top panel is inverted, but the rings are mounted,
to enable it to be transported without any prior set-up required. The angle of the cables must
be greater than 45º
Figure 3: Transport of an cabinet AFQm by crane�