Circutor AFQm Series, Инструкция по эксплуатации

Страница: 14 / 108

14
AFQm
Instruction Manual
3.2.- INSTALLATION LOCATION
The device must be installed in an environment where the temperature outside the cabinet is
between -10ºC and 45ºC, with a maximum humidity of 95% without condensation.
Do not install the device close to a hot spot and keep it out of direct sunlight.
Install the AFQm in a place protected from water, dust, flammable liquids, gases
and corrosive substances.
Make sure there are no power factor correction devices installed in the same
mains as the AFQm .
If there are any compensation devices, these must be detuned in order to avoid
interference between them and the AFQm .
3�2�1�- VENTILATION REQUIREMENTS
3�2�1�1�- Wall-type AFQm
The device has a power control system that controls the rotation speed of the fans and the
maximum power of the device according to the internal temperature, to ensure the best perfor-
mance in any condition.
Table 7: Ventilation distances: Wall-type AFQm�
Ventilation distances : Wall-type AFQm
50 mm 400 mm
3�2�1�2�- Rack-type AFQm
The Rack-type AFQm uses a forced ventilation cooling system, with an air inlet on the front
panel and an air outlet at the back of the device.
Once installed, the device’s flows of inlet air and outlet air must be allowed to circulate freely. At
maximum power, the Rack-type AFQm circulates an airflow of 375 m
3
/h .
The device has a power control system that controls the rotation speed of the fans and the
maximum power of the device according to the internal temperature, to ensure the best perfor-
mance in any condition.
To maintain the device’s performance, we recommend ensuring that the air circulates freely
through the front panel of the Rack-type AFQm , and that the rear is free of obstacles, with a
gap of at least 300 mm .