Circutor AFQm Series, Инструкция по эксплуатации

Страница: 24 / 108

24
AFQm
Instruction Manual
3�6�3�- CABINET-TYPE AFQm : AFQm-xxx-100C, AFQm-xxx-200C, AFQm-xxx-300C AND
AFQm-xxx-400C
CIRCUTOR has two types of cabinets: cabinets with connections at the top and cabinets with
connections at the bottom.
There are sliding windows at the bottom of the cabinet so that the connection wiring can be
slotted inside,
Figure 14
. These windows can be removed and machined if it is considered nec-
essary to use a cable gland.
Figure 14: Sliding windows for the connection wiring�
You should never remove the cover closest to the front part.
Cabinets with connections at the top have a sheet in the upper part of the cabinet which can be
machined as shown in
Figure 15
, to insert the connection wiring.
72
80 80 80 138
75
Unidades en mm. / Units in mm.
Figure 15: Machining a cabinet with connections at the top�
The current input and the communication ports must be connected to the “ master ” device,
which is the located at the top of the cabinet. This connection is described in “
3.6.2.- RACK-
TYPE AFQm: AFQm-xxx-100R
”.
To access the current input and mains connections, loosen the screws in the lower front cover
(in cabinets with connections at the bottom) or the screws in the upper front cover (in cabinets