Ciara Kronos 600 X79-KA SERIES, Руководство пользователя

Страница: 21 / 228

CIARA Kronos 600 workstation X79-KA-XXXXX-XX-XXX
- 21 -
1.5.8 Solving memory problems
Solving memory problems
Problem
Cause Solution
System will not boot or does not
function properly after installing
additional memory modules. Memory module is not the
correct type or speed grade
for the system or the new
memory module is not seated
properly. Replace memory module with a module approved
for your system. See Sections 1.6.4 and 4.23 of the
present Guide to verify if you have installed memory
modules compatible to your system and if they were
installed correctly.
Out of memory error. You have run out of memory
to run the application. Check the application documentation to determine
the memory requirements.
Insufficient memory error
during operation. Too many programs are being
used. Close any programs that you do not need.
You have run out of memory
for the application. Check the memory requirements for the application
or add more memory to the computer.
Power LED flashes five times,
once every second, followed by
a two second pause, and the
computer beeps three times. Memory is installed
incorrectly or is bad. 1. Reseat DIMMs. Power on the system.
2. Replace DIMMs one at a time to isolate the
faulty module.
3. If a faulty module is found, Contact CIARA for
the replacement of the module.
4. 4. If the problem persists, Contact CIARA for this
may necessitate the replacement of the
motherboard.
1.5.9 Solving processor problems
Solving processor problems
Problem
Cause Solution
Poor performance is experienced. Processor is hot. 1. Make sure the airflow to the computer is not
blocked.
2. Make sure the fans are connected and working
properly (some fans only operate when needed)
3. Make sure the processor heatsink is installed
properly.
4. Make sure the processor fan connector is
properly connected to the CPU_FAN header on
the motherboard.
5. Make sure sufficient thermal compound has
been applied on the processor before the heat
sink is put in place. This ensures that heat is
drawn away from the processor to the heat sink.
6. 6. Replace the heat sink with more efficient
model.
Power LED is always on
OR
Power LED flashes three times,
once every second, followed by a
two second pause. Processor is not seated
properly or not installed. 1. Check to see that the processor is present.
2. Reseat the processor. See section 1.6.3 of the
present Guide for more information.
Computer does not start. 4-pin ATX12V power
connector is not connected
to the motherboard. Connect the 4-pin ATX12V power connector to the
motherboard.
Power supply does not meet
the power requirements of
the processor. Replace power supply with a compatible model that
meets or exceeds the power requirements of the
processor.