Chison Q9, Руководство по эксплуатации, Страница: 30 / 201

Q9 Digital Color Doppler Ultrasound System
24
NOTE:
If the system is down or has not fully shut down, press and hold the Power button located on
the left of control panel
for more than 4 seconds and release it, this will force the system to shut
down completely.
Disconnect the probes. Clean or disinfect all probes as necessary. Store them in their
original cases to avoid any damage.
To ensure the system is disconnected from the power source, disconnect power plug from
the wall outlet.
3.5. Probes
NOTE:
Only use the probes approved by Manufacturer.
Selecting probes
Choose the probe according to the different examination.
Begin the scanning session by choosing the correct application and preset for the examination.
Connecting the Probe
When you connect the probes, please ensure that the probe ports are not active. Place the system in
“Transducer Selection” interface by pressing PROBE-key to deactivate the probe ports.
To connect a probe:
Place the probe’s carrying case on a stable surface and open the case.
Carefully remove the probe and unwrap the probe cord.
DO NOT allow head of the probe hang freely. Impact to head of the probe could result in irreparable
damage.
NOTE:
Inspect the probe before and after each use for damage or degradation to the housing,
strain relief, lens, seal and connector. DO NOT use a probe that appears damaged until its
functional and safe performance is verified. A thorough inspection should be performed
during the cleaning process.
Align the connector with the probe port and carefully push into place with the cable facing the back of the
system.
Turn the probe connector locking lever to “lock” status.