Carbide 3D Shapeoko XXL, Руководство пользователя

Страница: 79 / 110

The Z-Axis homing switch plate attaches to the
front of the X/Z assembly using four (4x) M5x10mm
button head cap screws.
Make sure the limit switch is located in the bottom
left corner of the plate (when viewed from the
front of the Shapeoko XXL) before securing to the
standoffs. You can identify the location of the
switch by looking for the small hex nut on the
outside of the plate.
NOTE: Depending on how your harness was
pre-assembled and whether any shifting
occurred during shipment, it may be necessary
to clip the top zip-tie to allow for more of the
black-and-yellow twisted wire to be pulled
through the Drag Chain.