Carbide 3D Shapeoko XXL, Руководство пользователя

Страница: 38 / 110

Use the hex wrench to tighten the Tensioning
Screw as shown in the image below. As the
Tensioning Screw is tightened, it will push on the
Idler Assembly.
The belt should be tight enough that it doesn’t slip
off the Idler and does not flex as the carriage
moves up and down.
When the belt is tight, use a 4mm hex key and
10mm wrench to tighten the Idler Assembly as
shown in the image below.
Install Springs
Lay the X/Z Carriage on one of its sides as shown in
the image below. Place one of the spring’s loops
around the Z Carriage post as shown in the image
below.