Carbide 3D Shapeoko XXL, Руководство пользователя

Страница: 22 / 110

Insert 3x M5x25mm screws into the three
countersunk holes as shown in the image above.
Turn the screws until they stop but do not tighten.
Rear End Plate
Carefully lift the rear edge of the Cross Straps/MDF
Baseplate assembly and insert a single End Plate as
shown in Figure X. Note that the flange on the End
Plate will go beneath the Cross Straps and the six
holes drilled into the End Plate will match up to the
six countersunk holes running along the rear edge
of the two MDF Baseplates.