Canon XF705, Инструкция по эксплуатации

Страница: 93 / 231

93
S ynchronizing with an External Device
5 Pu s h the joy s tic k up/down to s elect the fir s t digit and pre ss S ET to move to the next.
• Change the rest of the digits in the same way to adjust the H phase to the desired level (–1023 to 1023).
• Press the CANCEL button to return to the previous screen without setting the Genlock adjustment value.
6 S elect [ S et] and then pre ss S ET.
NOTES NOTES
• When a suitable Genlock signal is input, the Genlock synchronization stabilizes after approximately
10 seconds.
• When a suitable Genlock signal is detected, the
U
icon will flash at the top right of the screen. When the
camcorder locks on the external Genlock signal, the icon will stay on.
• If the external Genlock signal is incorrect, the synchronization may not be stable. In such case, the recorded
time code may be incorrect.
Time Code S ignal Input
An external SMPTE-standard LTC timing signal received from the TIME CODE terminal will be recorded as the
time code. The user bit of the external timing signal can also be recorded with the clips. Before connecting the
device, set the TIME CODE terminal to input. Also, you must set the running mode of the time code to [Free Run]
(
A
88).
1 S elect [TC In/Out].
>
[
B
#
System Setup]
>
[TC In/Out]
2 S elect [In] and then pre ss S ET.
Recording the User Bit of an External Signal
The user bit of an external time code signal can also be recorded with clips along with the time code itself.
1 Select [User Bit Recording Mode].
>
[
B
#
System Setup]
>
[User Bit Recording Mode]
2 Select [External] and then press SET.
NOTES NOTES
• When the frame rate is set to 23.98P, use a 24-frame time code signal as input signal. When it is set to 25.00P,
50.00i or 50.00P, use a 25-frame time code signal. For other frame rates, use a 30-frame time code signal.
• When a suitable time code signal is received, the camcorder’s own time code will be synchronized to it and the
synchronization will be maintained even if you disconnect the cable from the TIME CODE terminal.
• If the external time code signal is incorrect or there is no input signal, the internal time code (as set with the
menu settings in the [
B
#
System Setup] menu page) will be recorded instead.
• While a time code signal is being received, the external time code’s drop-frame bit will be used.
• Performing any of the following actions while the cable is not connected will cause the synchronization to be
disrupted; the correct time code will be restored once you reconnect the cable.
- Turning the camcorder off/on
- Changing the operating mode to
mode
- Changing the video configuration
Operating modes: