Canon XF705, Инструкция по эксплуатации

Страница: 88 / 231

S etting the Time Code
88
S etting the Time Code
In mode, the camcorder generates a time code signal and records it with the recorded clips. The time
code signal can be output from the SDI terminal, HDMI OUT terminal and TIME CODE terminal. In mode,
the time code embedded in the clip being played back can be output from the SDI terminal.
Depending on the frame rate used, you may be able to select between a drop frame an non-drop frame time
code signal (
A
89). The default mode varies depending on the country/region of purchase and, though the time
code display style is different for DF and NDF, in this section the NDF display style is used for simplicity’s sake.
S electing the Time Code Mode
You can select the camcorder’s time code mode.
1 S elect [Time Code Mode].
>
[
B
#
System Setup]
>
[Time Code Mode]
2 S elect the de s ired option and then pre ss S ET.
Option s
[Preset]: The time code starts from an initial value you can select in advance. The default initial time code
is 00:00:00:00.
See the following procedures to select the time code running mode and set the initial time code.
[Regen.]: The camcorder will read the selected SD card and the time code will continue from the last time
code recorded on the card. The time code runs only while recording so clips recorded
consecutively on the same card will have continuous time codes.
Setting the Time Code Running Mode
If you set the time code mode to [Preset], you can select the time code running mode.
1 Select [Time Code Run].
>
[
B
#
System Setup]
>
[Time Code Run]
2 Select the desired option and then press SET.
Option s
[Rec Run]: The time code runs only while recording so clips recorded consecutively on the same card will
have continuous time codes.
[Free Run]: The time code starts running the moment you press SET and keeps running regardless of the
camcorder’s operation.
Operating modes: