Analogue Telephony Adaptor User Manual
9
IVR Network Configuration
47
9
IVR Network Configuration
Accessing the Network Configuration Menu
To access the IVR Network Configuration menu:
Lift the handset
If the product is working correctly and you hear no diagnostic message:
Press ‘#’ to reach the IVR dial by name directory.
Press ‘#’ again to reach the Management Web Page read out.
Press ‘#’ again to reach the Network Configuration menu.
If the product is not working correctly and you hear a diagnostic message:
Press ‘#’ again to reach the Management Web Page read out.
Press ‘#’ again to reach the Network Configuration menu.
In both cases you should hear “Please Choose Mode” to signify that the
Flexor 151 is ready for your network configuration.
Configuring Network Settings
Select configuration mode by pressing the appropriate digit shown below:
‘0’ Automatic
‘1’ DHCP
‘2’ Emulate PC Settings
‘3’ Manual
To understand the meaning of these different network
configuration settings see Network Settings on page 45.
If you entered Automatic, DHCP or Emulate PC Settings you should hear
“OK” to confirm that the settings has been changed.
If you entered Manual you will now need to enter the IP address. To enter
the IP address:
Enter the digits of the IP address using the telephone digits.
Enter a ‘*’ for a ‘.’ in the IP address.
Enter a ‘*’ to complete the IP address entry.
For example, to enter the IP address 192.168.0.1 you would press
192*168*0*1*.
You should hear “OK” to confirm your setting has been accepted. You
should now configure the rest of the settings using the management web
pages, see
Network Settings on page 45.
If you hear “Incorrect”, start the process again.
Note
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030
