Analogue Telephony Adaptor User Manual
7
Managing the device
39
Call management
The call management section of the Flexor 151 web pages allow you to
configure what happens to incoming land-line calls. This configuration is
closely tied to the buttons on the Flexor 151 as described in
Buttons and
LED indicators on page 11.
The Call Management page is shown below:
A number of different actions are possible for an incoming call:
Ring the phone as normal; eventually ringing-out to voicemail if the
call is not answered in time.
Allow the phone to ring a specified number of times, and then do one
of the following:
Redirect to voicemail
Divert to a specified number
Enter hop on/off mode (if the incoming call was over a land line)
Note that only one of the above (voicemail, divert, hop on/off)
features can be used at once.
By default, none of these above actions are enabled on the device. An
incoming call will either stay ringing or divert to any voicemail feature you
have setup on your home phone.
The following sections describe how to configure the Flexor 151 to enable
the actions described above for incoming calls.
Setting up Hop on / off
Hop on / off enables you to take advantage of VoIP from other phones
such as a mobile phone. The basic idea is that you can use the Flexor 151
to ‘bridge’ between a land-line and VoIP.
So for example, you wish to make an international call from you mobile
phone. This call would be much cheaper using VoIP but your mobile phone
Note
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030
