Analogue Telephony Adaptor User Manual
4
Configuring the device
16
However, if it is not convenient for you to install the Flexor 151 in this
network setup, you are free to connect it in any manner as long as the PC
and the Flexor 151 are on the same local network.
The steps to follow to connect the Flexor 151 are described below.
Step 1. Connect the Ethernet cables and telephone lines
Connect the provided phone cables to the appropriate ports of the device
as shown on the Installation Sheet. If required, use the phone adaptor to
convert the RJ11 connector to a suitable connector for your country.
Connect the provided Ethernet cable to the appropriate port on your device
and connect your PC to the device using another Ethernet cable.
Step 2. Attach the power connector
Connect the AC power adapter to the Power connector on the back of the
device and plug the adapter into a wall outlet or power strip.
Turn on the power to the Flexor 151. The Flexor 151 will start up and
assuming it is connected to your network via an Ethernet cable it will
determine the best settings for your network.
If you wish to manually change the network settings see section
IVR
Network Configuration on page 47 for more information.
If your Flexor 151 has been supplied to you by your Voice
Over IP Operator or ITSP then you probably do not need to
configure the Flexor 151 to make VoIP calls. Once connected
correctly the Flexor 151 will configure itself automatically
with your operator’s settings enabling you to make calls
straight away. If this is not the case see
Configuring the
Flexor 151 below.
Note
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030
