Analogue Telephony Adaptor User Manual
4
Configuring the device
15
4
Configuring the device
This chapter provides basic instructions for connecting the Flexor 151 to
your phone, a computer or LAN and to the Internet and instructions on
configuring the device.
This chapter assumes that you have already established a broadband
service with your Internet service provider (ISP). These instructions
provide a basic configuration that should be compatible with your home or
small office network setup. Refer to the subsequent chapters for
additional configuration instructions.
Installing the Software
Before connecting the device, it is recommended that you
install the Voice Connect application on your PC. This
application helps to configure the Flexor 151. For more
information, see Installing the Voice Connect application on
page 53.
Connecting the Hardware
This section describes how to connect the device to the wall phone socket,
your phone, the power outlet and your computer(s) network.
The single-page Installation Sheet provided in the packaging with the
Flexor 151 should be referred to for instructions and help on cabling.
The diagram below illustrates the suggested connection set-up:
Internet
Broadband
Modem/Router
PC
Phone
Phone line
Flexor 151
Figure 4-1 - Illustration of Flexor 151 Set-up
For detailed connection information see
Figure 3-4
on page 14.
Figure 4-1
above shows the Flexor 151 connected inline with a PC, and
this is often the easiest way to install the Flexor 151. By taking the existing
Ethernet cable attached to your PC and using it to connect the Flexor 151,
you can be more certain that the Internet connection is valid.
Note
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030
