Caltest LXI AFX Series, Руководство пользователя

Страница: 259 / 402

AFX SERIES® OPERATION MANUAL
SECTION 8:
Remote Control Programming
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS)
• All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual Page 259 of 402
Command Syntax [SOURce:]WAVEFORM#:LOAD
Description This command loads the currently selected waveform to the actual
output register of the controller causing it output the waveform on
the selected phase #.
Parameters 1, 2, 3
Parameter Format <nr1>
Example WAVEFORM1:LOAD
Query Format [SOURce:]WAVEFORM#:LOAD? <nr1>
Returned Data Format <nr1>, <cr>
Query Example SOURce:WAVEFORM1:LOAD? 1
1, Sine
Command Syntax [SOURce:]WAVEFORM:RESTORE
Description This command restores the first 16 waveforms registers by replacing
waveform 1 to 16 with the factory defaults. See section 8.7.7.
Note: This command is useful if waveforms 2 through 15 were
overwritten with user-defined waveforms.
Parameters None
Parameter Format n/a
Example WAVEFORM:RESTORE
Query Format None
Command Syntax [SOURce:]WAVEFORM#:SELect
Description This command selects a waveform by alias (name) or number. When
using the WAVEFORM:x commands, the ALIAS|NUMBER is not
passed as it uses the selected one. This is to avoid passing the
waveform number to every command
Parameters <ALIAS|NUMBER, OPT: ALIAS|NUMBER , OPT: ALIAS|NUMBER >
The first parameter is required. Additional optional waveforms or
numbers may be added when operating the source in 2 or 3 phase
mode. The waveform selection sequence by phase is A, B, C.
Parameter Format <cr> or <nr1>
Example WAVEFORM:SEL SINE
WAVEFORM:SEL 1,2,3
WAVEFORM:SEL 5
Query Format [SOURce:]WAVEFORM#:SELect?
Returned Data Format <cr> or <nr1>
Query Example WAVEFORM:SEL?
1,1,1 (FORM 3)
WAVEFORM:SEL?
1,1 (FORM 2)
WAVEFORM:SEL?
1 (FORM 1)