Caltest LXI AFX Series, Руководство пользователя

Страница: 196 / 402

AFX SERIES® OPERATION MANUAL
SECTION 8:
Remote Control Programming
Entire Contents Copyright

2018 by Pacific Power Source, Inc. (PPS)
• All Rights Reserved • No reproduction without written authorization from PPS.
AFX Series Power Source Operation Manual Page 196 of 402
8.3 Calibration Commands
Calibration commands allow for fully automated calibration of the power source.
Note: It is not recommended for the end user to use these command unless calibration
must be automated. Any errors in using these commands could invalidate user
calibration data. Pacific Power Source recommends the use of a competent and
authorized calibration lab to perform routine calibration.
The following calibration commands are supported. Commands marked “UPC” are provided
for backward compatibility with UPC controller based PPS power sources.
8.3.1 AFX Calibration Commands
Command Syntax CALibrate:COEFFicients:OFFSET:VOLTage
Description Calibrates output DC voltage offset to lowest possible level.
Parameters None
Parameter Format n/a
Example CAL:OFFSET:VOLT
Command Syntax CALibrate:COEFFicients:OFFSET:CURRent
Description Calibrates output DC current offset to lowest possible level
Parameters None
Parameter Format n/a
Example CAL:OFFSET:CURR
Command Syntax CALibrate:COEFFicients:NOISE:VOLTage
Description Calibrates output voltage noise to lowest possible level.
Parameters None
Parameter Format n/a
Example n/a
Command Syntax CALibrate:COEFFicients:NOISE:CURRent
Description Calibrates output current noise to lowest possible level.
Parameters None
Parameter Format n/a
Example n/a