series instrument. You can select GPIB, USB, RS-485, RS-232, CAN or LAN
interface based on personal requirement.
1. Press the composite keys
[Shift]+[P-Set]
(System) to enter the System
menu interface.
2. Rotate the knob to select
I/O Config
and press
[Enter]
to confirm.
3. Rotate the knob to select the communication interface and press
[Enter]
to
confirm, and also set the parameters of interface.
Please refer to
for the detailed description of each
communication interface parameter.
4. Press
[Esc]
key to exit.
7.4.5 Select Trigger Source
This series Power supply supports the following trigger sources:
•
KeyPad: Default value, Select the front panel
[Shift]+[On/Off]
(Trigger)
button as the trigger source.
•
Bus: Select the remote interface command as the trigger source, such as
the
*TRG
command.
The procedures to set the menu item are as follows.
1. Press
[Shift]+[P-set]
（
System
）
to enter the system menu interface.
2. Use left and right keys or rotate the knob to select
Trig Source
and press
[Enter]
to make the parameter in modification.
3. Rotate the knob to adjust the parameter KeyPad or Bus and press
[Enter]
.
7.4.6 Restore the Factory Default Settings
This menu item is used to restore the factory default settings. The procedures to
set the menu item are as follows.
1. Press
[Shift]+[P-set]
(System) to enter the System menu interface.
2. Rotate the knob to select
System Reset
and press
[Enter]
.
3. Rotate the knob to select
Yes
or
No
and press
[Enter]
to confrim.
•
No: default value, indicates cancels this menu setting.
•
Yes: indicates the instrument restores the factory default settings.
Copyright © Itech Electronic Co., Ltd.
77
