6. After setting, press
[Esc]
to exit.
Enable LAN Service
The configurable services include: mDNS, Ping, Telnet, Web, VXI-11 and Raw
Socket. When using the LAN interface, these services are enabled by default
and can be used directly. If you need to turn it off or on again, please refer to the
following steps:
1. Press
[Shift]+[P-Set]
(System) to enter into the system menu interface.
2. Use left and right keys or rotate the knob to select
I/O Confg
and press
[Enter]
key to confirm.
3. Use left and right keys or rotate the knob to select
LAN
and press
[Enter]
key to confirm.
4. Use left and right keys or rotate the knob to select
Lan Config
and press
[Enter]
key to confirm.
5. Use left and right keys or rotate the knob to select
Server_Config
and press
[Enter]
key to confirm.
6. Use left and right keys or rotate the knob to select the desired item and
press
[Enter]
key to confirm.
User need to set the Socket Port when enable the Raw Socket service.
7. Rotate the knob to adjust the parameter and press
[Enter]
key to confirm.
•
On: enable the service.
•
Off: disable the service.
8. After setting, press
[Esc]
to exit.
2.6.3.1 Using the Web Interface
The instrument has a built-in Web interface for monitoring and controlling the in-
strument via a Web browser. To use the Web interface, connect the instrument
and PC over LAN and enter the instrument's IP address into the address bar at
the top of your PC's Web browser, you can access the front panel control func-
tions including the LAN configuration parameters.
•
Please confirm the IP address and Gateway is configured correctly. The detailed
information refer to the Configure LAN Interface Information.
•
You must enable Web service if you wish to remotely control your instrument us-
ing its built-in Web interface. Refer to LAN services setting for the detailed oper-
ation procedures.
•
Up to six simultaneous connections are allowed. With additional connections,
performance will be reduced.
Copyright © Itech Electronic Co., Ltd.
30
