Cadac J-Type, Инструкция по установке и эксплуатации

Страница: 47 / 200

J-Type CCM 2-19
Revision J2005-2 J-Type
■ ■ ■ ■
Press the [
↑
] or [
↓
] cursor keys again until “P & N keys?” appears in the CCM dis-
play.
■ ■ ■ ■
Press [
↵
], to select the option.
The CCM display will show either:
“P & N keys: lit”
or
“P & N keys: unlit”
or
“P & N keys: flash”
■ ■ ■ ■
Press the [
↵
] key to cycle through three options.
When the required option is set, press [Esc] to return to one of the “root” displays.
519157 0,', # 3& 0 ILOWHU
The MIDI Program Change filter can be selected on or off.
When the MIDI Program Change filter is “on”, only the first Program Change mes-
sage for a specific MIDI Channel is sent. Any identical PC messages to the same
channel are filtered out.
Alternatively, when the MIDI Program Change filter is “off”, all PC messages are
sent, whenever they appear in the data.
The reason for including this option, is that some types of MIDI controlled equipment
“close down” for a short time when a PC message is received, causing a brief loss of
the audio signal. It is therefore unnecessary and undesirable to repeat the same PC
number.
■ ■ ■ ■
Press the [Sys] key to use the System Setup menu.
■ ■ ■ ■
Press the [
↑
] or [
↓
] cursor keys until “User Setup?” appears in the CCM display.
■ ■ ■ ■
Select the sub-menu by pressing [
↵
].
7KH # &&0 # GLVSOD\ # ZLOO # UHVSRQG # ZLWK #
“User Setup
⇑⇓
“.
■ ■ ■ ■
Press the [
↑
] or [
↓
] cursor keys again until “MIDI PC filter?” appears in the CCM
display.
■ ■ ■ ■
Press [
↵
], to select the option.
The CCM display will show:
“PC filter on” or “PC filter off”
■ ■ ■ ■
Press [
↵
], to toggle between on and off.
When the required option is set, press [Esc] to return to one of the “root” displays.
519158 0,', # $OO # 1RWHV # 2II
When a Note On message is sent to MIDI equipment, the note will “play” continu-
ously until a Note Off message is received.
If a Cue sequence is terminated before the Note Off message is sent, then the note
will carry on “sounding”, and may cause a problem. The MIDI All Notes off option is
designed to deal with this problem.
If you select “MIDI All Notes Off: Yes”, then an All Notes Off message is sent on each
channel of a particular port when the relevant MIDI O/P Port Enable switches is set
“off”.
■
■ ■
■
Press the [Sys] key to use the System Setup menu.