Cadac J-Type, Инструкция по установке и эксплуатации

Страница: 51 / 200

7865 Stereo Input Channel 3-1
Revision J2005-2 J-Type
6 3URJUDPPDEOH # PRGXOHV #0# LQSXW
J-Type programmable modules add switch
RESET and/or potentiometer RECALL
automation to the original Fader, Events and MIDI automation available as standard
to the J-Type console system.
614 :;98# 6WHUHR # ,QSXW # &KDQQHO
The left and right inputs have separate controls for gain, 20dB pad, phase-change,
phantom power, on/off and PFL. This allows either input to be used with either one
stereo or two mono microphones or line level sources. The Oscillator Bus can be
injected into both input amplifiers and all input switching can be isolated from the
computer.
The stereo direct output may be selected pre or post the channel fader, and/or pre or
post the EQ section.
Routing switches to all 16 sub groups are provided. When working with a stereo
input, left hand signals appear on ‘odd’ numbered sub groups and right hand signals
appear on ‘even’ numbered sub groups. However, when the dual-concentric pan-pot
is inserted, either input may be ‘panned’ between any combination of ‘odd’ and ‘even’
sub groups. The pan-pots also control the panning for the stereo auxiliary send sec-
tion.
There are ten mono and one stereo auxiliary send sections. Each of the aux-sends
can be switched on/off and pre or post fader, and have individual level controls.
The four-band stereo equalizer has controls for ±18 dB boost or cut, variable fre-
quency and “Q”. Variable frequency low-pass and high-pass filter sections are also
included.
An external stereo audio processing device can be connected to the module via
‘TRS’ send and return jacks. The external processor is connected in series with the
channel signal when ‘Insert’ is selected. The EQ and Filters can be switched pre or
post the insert point.
All audio inputs and outputs are electronically balanced.