Cadac J-Type, Инструкция по установке и эксплуатации

Страница: 103 / 200

7548 Programmable Routing - Slave Mod. Mk II 4-17
Revision J2005-2 J-Type
716## :87;# 3URJUDPPDEOH # 5RXWLQJ #0# 6ODYH # 0RG 1# 0N # ,,
The PRM Mk II is a single section Slave Routing module with up to four selectable
line level audio inputs. Single or mixed input signals can be routed to any of the 16
Sub Groups and 32 Matrix groups available on the standard J-Type console system
using the 6908 or 7925 series Group modules plus any or all of the Aux Send bus-
ses. If the 7170 series Group modules are used, then the Slave Routing module can
only route to 16 Sub Groups and 16 Matrix groups. Think of the PRM Mk II as a spe-
cialized input channel.
Each PRM Mk II is intended for use with a channel fader which should be mounted
directly below the module. Although the module was originally designed for use with
a CADAC motorized fader, a standard VCA fader may be used if required.
An insert point is provided after the input mixing stage and before the fader. The bal-
anced send and return connectors are mounted on the rear panel (TRS jacks).
All audio switching is done using relays and the condition of each switching function
is programmed using the Sound Automation Manager software. Any or all inputs can
be routed to any or all J-Type Sub, Matrix and Aux groups. The Sub and Matrix group
selection is shown on the LED display mounted near the top of the module and the
Aux 'ON' and 'PRE' functions are displayed to the left of the Aux Send pots.
PRM Mk II's can be used in the same frame with PRM Mk I's. However, PRM Mk I's
must be placed in one contiguous 'group' and PRM Mk II's in another contiguous
'group'. If PRM Mk II's are retro-fitted to an existing console, you must map the mod-
ules to “tell” the system that they are present.
Please refer to figure 3-1 for the position of the controls and switch functions
described below.