Cadac J-Type, Инструкция по установке и эксплуатации

Страница: 69 / 200

7496 Dual Input Channel 3-19
Revision J2005-2 J-Type
615173 +0) # (4 # %RRVW 2 &XW # DQG # )UHTXHQF\ # &RQWURO
A dual-concentric potentiometer where the ‘inner’ knob is the ‘Boost/Cut’ control for
the EQ section and the ‘outer’ knob is the ‘Frequency’ potentiometer.
Boost/Cut±18 dB
FrequencyVariable from 400Hz to 4kHz
615174 /0) # (4 # ¶4· # &RQWURO
The ‘Q’ control varies the bandwidth of the EQ section in the range Q=1 to Q=3. A
low value of Q gives a wide bandwidth. This means that a relatively large range of
frequencies (either side of the centre frequency selected by the ‘Frequency’ control)
have boost/cut applied. As the value of Q is increased, the bandwidth is reduced, so
that a very much smaller range of frequencies have boost/cut applied.
615175 /0) # %RRVW 2 &XW # DQG # )UHTXHQF\ # &RQWURO
A dual-concentric potentiometer where the ‘inner’ knob is the ‘Boost/Cut’ control for
the EQ section and the ‘outer’ knob is the ‘Frequency’ potentiometer.
Boost/Cut±18 dB
FrequencyVariable from 60Hz to 600Hz
615176 /) # (4 # ¶4· # &RQWURO
The ‘Q’ control varies the bandwidth of the EQ section in the range Q=1 to Q=3. A
low value of Q gives a wide bandwidth. This means that a relatively large range of
frequencies (either side of the centre frequency selected by the ‘Frequency’ control)
have boost/cut applied. As the value of Q is increased, the bandwidth is reduced, so
that a very much smaller range of frequencies have boost/cut applied.
615177 /) # %RRVW 2 &XW # DQG # )UHTXHQF\ # &RQWURO
A dual-concentric potentiometer where the ‘inner’ knob is the ‘Boost/Cut’ control for
the EQ section and the ‘outer’ knob is the ‘Frequency’ potentiometer.
Boost/Cut±18 dB
FrequencyVariable from 20Hz to 200Hz
615178 (4 # ¶,Q 2 2XW·
Press the “EQ IN” button to put the equalizer into the channel signal chain.
615179 /3 # )LOWHU # ¶,Q 2 2XW·
Press the “LP IN” button to put the Low Pass Filter into the channel signal chain.
61517: +3 # )LOWHU # ¶,Q 2 2XW·
Press the “HP IN” button to put the High Pass Filter into the channel signal chain.
61517; (4 # DQG # )LOWHUV # ¶3UH· # RU # ¶3RVW· # ,QVHUW
The default routing for the EQ and Filter sections is ‘post’ the insert point.