Cadac J-Type, Инструкция по установке и эксплуатации

Страница: 49 / 200

J-Type CCM 2-21
Revision J2005-2 J-Type
*URXS 0 /LQN # RQ
In Group-Link mode, the DC master faders can “move” channel faders. AUX from
VCA does not have the same meaning as in a non-motor fader system.
When AUX VCA is not selected on a channel fader:
■ ■ ■ ■
The channel fader MUTE button only effects the main audio output from a chan-
nel
■
■ ■
■
When the AUX VCA switch is selected on a fader:
■ ■ ■ ■
The channel fader MUTE button affects the main and the post fader aux. send
signals from the channel.
Channel faders selected to a DC master fader will always “follow” the DC master
Fader. Channel and DC master faders may be programmed for “Snapshot” position
changes and can be used in dynamic cues.
0RWRU # IDGHU # EHKDYLRXU # ZKHQ # VZLWFKLQJ # EHWZHHQ # PRGHV
When entering or leaving Group-Link mode, the channel fader position will change if
it is assigned to a VCA group other than 0, and the relevant DC master is set at a
position other than 0dB
51915: 7ZLQ # PDVWHUV
This option is used in the event that an external master fader box is connected to the
console. When “twins” are enabled, moving a Master Fader will cause its twin to
move in the same way. This allows a modicum of remote control.
■
■ ■
■
Using the arrow keys, select “Twin masters” in the menu “User Setup” and press
[
↵
].
■ ■ ■ ■
Select the number tax of Twin masters in the box, by pressing [
↵
] until the
number appears on the CCM display.
Press [Esc] to go back to the “User Setup” menu.
51915; (YHQW # GXUDWLRQ
The Events-function allows control of external equipment, such as CD-players, tape-
decks, effects-boxes etc. via 8 relays within the CCM. These relays can be in one of
three states:
ON = always on
OFF = always off
PULSE = toggles between on and off
PULSE duration can be set to a value (1-25) as required to control the external
equipment.
■ ■ ■ ■
Using the arrow keys elect “Event Duration” in the menu “User Setup” and press
[
↵
].
■ ■ ■ ■
The display shows “Event Dur: “
■
■ ■
■
Press [
↵
] again until PULSE is set to a value between 1-25 (25 = 3 sec).
Press [Esc] to go back to the “User Setup” menu.