Cadac J-Type, Инструкция по установке и эксплуатации

Страница: 175 / 200

7934 Stereo VCA Fader 8-3
Revision J2005-2 J-Type
Aux VCA ‘off’: If any of the Aux Sends on a channel are set to send signal post-fader,
the channel fader will directly control the signal level sent to the Aux mix bus. A DC
master selected for the channel fader or the faders mute will have no effect.
Aux VCA ‘on’: If any of the Aux Sends are set to send signal post-fader and a DC
Master fader is selected for the channel fader, the DC Master fader will control the
overall of the signal to the Aux mix bus in addition to the channel fader.
;1417 *URXS # VHOHFWLRQ
Press the (+) button to increment the DC Master group number and the (-) button to
decrement the DC Master group number. The DC Master group number selected is
shown on the hexadecimal display above the switches. This can also be pro-
grammed as part of a cue.
;1418 ,VRODWH
When this button is pressed, the fader is disconnected from the computer system. It
cannot send commands to the computer and it cannot receive commands to the
computer.
All faders can be put in isolate mode by pressing the ALL FADER ISOLATE “SET”
SWITCH on the master fader control panel below the CCM module. Similarly, all fad-
ers can be taken out of isolate mode by pressing the ALL FADER ISOLATE “CLEAR”
switch on the same panel.
;1419 %\ 0 SDVV
When this button is pressed, the fader behaves as if it is a manual device with no
VCA grouping. Data may, however, be sent to or received from the computer, but
cannot be used until the By-pass mode is switched ‘off’.
All faders can be put in By-pass by pressing the ALL FADERS BY-PASS “SET” switch
on the master fader control panel below the CCM module. Similarly, all faders can be
taken out of By-pass mode by pressing the ALL FADER BY-PASS “CLEAR” switch on
the same panel.
;141: )DGHU
A 100 mm standard fader controls the signal level to the sub group and post-fader
Aux Sends.
;141; /(' # PHWHU
Two 20-segment LED bargraph meters indicate the stereo channels level post EQ
and INSERT points.
;141< )DGHU # 2SHQ
This LED lights when the fader is open and not muted (and when any assigned DC
Master is open and not muted).