Cadac J-Type, Инструкция по установке и эксплуатации

Страница: 64 / 200

3-14 7496 Dual Input Channel
J-Type Revision J2005-2
615148 2VFLOODWRU # %XV # 6HOHFW
Press this button to connect inputs 1 and 2 to the ‘Oscillator/PNG’ bus. For this func-
tion to work, the ‘Oscillator/PNG’ module must be selected to “CHANNELS”. This
facility allows you to check that an individual module, or the whole console is working
correctly.
615149 ,QSXW # $PSOLILHU # ,VRODWH
This function ‘isolates’ the switch and potentiometer recall data (for both input ampli-
fiers) from the computer. There are many instances during a production rehearsal,
when module routing or level changes need to be made to solve a problem. When
you are rehearsing a sequence of cues, there may not be time to record the changes
in all of the cues that are affected. When you press the ‘ISOLATE’ button, previously
recorded switch and pot data will be ignored by the module, leaving the controls at
their new setting until you cancel the function.
61514: 'LUHFW # 2 2 3 # ¶3UH· # (4
The default setting for the channel ‘direct output’ circuit is post-EQ and pre-fader.
When the ‘direct output’ is used to feed an external monitor mixer or recording
machine, it is possible that the EQ settings for the ‘front-of-house’ mix will clash will
the requirements for these purposes.
Press this button to derive the ‘direct output’ signal ‘pre’ the channel EQ.
61514; 'LUHFW # 2 2 3 # ¶3RVW· # &KDQQHO # )DGHU
The default setting for the channel ‘direct output’ circuit is post-EQ and pre-fader.
Press this button when you need to control the ‘direct output’ level with the channel
fader.
61514< 6XE # *URXS # 5RXWLQJ # 6ZLWFKHV
Sixteen switches that allow you to route the channel signal to one or all of the Sub
Group routing bus’.
615153 6XE # *URXS # 5RXWLQJ # /('V
Sixteen LEDs which when lit indicate to which Sub Groups the channel signal has
been routed. Using the A & B buttons also allow routing to the 32 Matrix.
615154 0DWUL[ # $ # VHOHFW
Selecting MAT A will cause the MAT A LED to flash and the routing to matrix A (1-16)
is again selected by the appropriate square button. When selected ON the relevant
LED will illuminate. This action does not affect the state of the Sub Groups.
615155 0DWUL[ # % # VHOHFW
As for 3.2.21.