Cadac J-Type, Инструкция по установке и эксплуатации

Страница: 67 / 200

7496 Dual Input Channel 3-17
Revision J2005-2 J-Type
61515; $X[ # 6HQG # ¶2Q 2 2II·
The default setting for the channel auxiliary send circuits is ‘off’ and post-fader.
Press the “ON” button to switch the aux send section into circuit.
61515< $X[ # 6HQG # /HYHO
Level control for an auxiliary send section.
The position of the ‘level’ potentiometer is recorded during a SAVE command.
615163 $X[ # 6HQG # 3RW # 1XOO # /('
The Null LED will be illuminated if the position of the ‘aux send pot’ is different from
the programmed position. To recall the programmed position, rotate the potentiome-
ter until the LED goes ‘out’.
615164 6WHUHR # $X[ # 6HQG # ¶3UH 0 (4·
The default setting for the channel auxiliary send circuits is ‘off’ and post-EQ.
Press the ‘PRE’ button until the PRE EQ LED illuminates to derive the stereo aux
send signal pre-EQ.
615165 6WHUHR # $X[ # 6HQG # ¶3UH 0 )DGHU·
The default setting for the channel auxiliary send circuits is ‘off’ (post-fader).
Press the “PRE” button until the PRE FD illuminates to derive the stereo aux send
signal pre-fader.
615166 6WHUHR # $X[ # 6HQG # ¶2Q 2 2II·
The default setting for the channel auxiliary send circuits is ‘off’ (post-fader).
Press the “ON” button to switch the stereo aux send section into circuit.
615167 6WHUHR # $X[ # 6HQG # /HYHO # 3RW # 1XOO # /('
The Null LED will be illuminated if the position of the ‘stereo aux send pot’ is different
from the programmed position. To recall the programmed position, rotate the potenti-
ometer until the LED goes ‘out’.
615168 6WHUHR # $X[ # 6HQG # /HYHO # DQG # ¶3DQ·
A dual-concentric potentiometer where the ‘inner’ knob is the level control for the ste-
reo auxiliary send section and the ‘outer’ knob is the stereo aux ‘pan pot’. The posi-
tions of the ‘level’ and ‘pan’ potentiometers are recorded during a SAVE command.
615169 6WHUHR # $X[ # 6HQG # ¶3DQ # 3RW· # 1XOO # /('
The Null LED will be illuminated if the position of the ‘stereo aux pan pot’ is different
from the programmed position. To recall the programmed position, rotate the potenti-
ometer until the LED goes ‘out’.